ICM7243
®
8-Character, MicroprocessorCompatible, LED Display Decoder Driver
August 1997
Features
Description
• 14-Segment and 16-Segment Fonts with Decimal Point
The ICM7243 is an 8-character, alphanumeric display driver
and controller which provides all the circuitry required to
interface a microprocessor or digital system to a 14-segment
or 16-segment display. It is primarily intended for use in
microprocessor systems, where it minimizes hardware and
software overhead. Incorporated on-chip are a 64-character
ASClI decoder, 8 x 6 memory, high power character and
segment drivers, and the multiplex scan circuitry.
• Mask Programmable for Other Font-Sets Up to 64
Characters
• Microprocessor Compatible
• Directly Drives LED Common Cathode Displays
• Cascadable Without Additional Hardware
6-bit ASCll data to be displayed is written into the memory
directly from the microprocessor data bus. Data location
depends upon the selection of either Sequential
(MODE = 1) or Random access mode (MODE = 0). In the
Sequential Access mode the first entry is stored in the
lowest location and displayed in the “left-most” character
position. Each subsequent entry is automatically stored in
the next higher location and displayed to the immediate
“right” of the previous entry. A DISPlay FULL signal is provided after 8 entries; this signal can be used for cascading
devices together. A CLeaR pin is provided to clear the memory and reset the location counter. The Random Access
mode allows the processor to select the memory address
and display digit for each input word.
• Standby Feature Turns Display Off; Puts Chip in Low
Power Mode
• Sequential Entry or Random Entry of Data Into Display
• Single +5V Operation
• Character and Segment Drivers, All MUX Scan
Circuitry, 8 x 6 Static Memory and 64-Character ASCll
Font Generator Included On-Chip
Ordering Information
PART NUMBER
TEMP.
RANGE (oC)
ICM7243AIJL
-25oC to 85oC 40 Ld CERPDIP
F40.6
ICM7243AIPL
-25oC to 85oC
E40.6
ICM7243BIJL
-25oC to 85oC 40 Ld CERPDIP
F40.6
ICM7243BlPL
-25oC to 85oC
E40.6
PACKAGE
40 Ld PDIP
40 Ld PDIP
PKG.
NO.
The character multiplex scan runs whenever data is not
being entered. It scans the memory and CHARacter drivers,
and ensures that the decoding from memory to display is
done in the proper sequence. Intercharacter blanking is
provided to avoid display ghosting.
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 321-724-7143 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright © Intersil Americas Inc. 2003. All Rights Reserved
All other trademarks mentioned are the property of their respective owners.
1
FN3162.1
