2.54 mm pitch connectors
Shunt plug for 0.6✕0.4 mm square contacts
DIC-131[Z-131]
For shunt
0.6✕0.4 mm square contacts
With lead wire
● Configuration of product Part No.
DIC-131
➀
➀ Series name
Contact plating: Min. 0.5 µm Gold plate
➀
3.7
0.1 REF.
Mating
direction
➁
Mating
direction
➂
4.7
2.3
19
•Shunt plug
•Male connector
DIC-131
DIC-148
Be careful not to insert
the contact into this lead
wire exit.
This plug cannot be mated
with the male connector
in this direction.
This skew angle is not allowed
to exceed 8 degrees.
(
➀ Insulator
➁ Lead wire
➂ Contacts
Mating connectors: DIC series of Straight DIP type male connectors for PCBs
SMT
Press-in
)
10.16 mm width
of the connector
• Prepare the arrangement of lead wires to prevent the skew of shunt plugs before mating these plugs
with the male connector.
• The lead wire should be laid down onto the platform floor of the male connector, or kept lower than
the top of the plugs, so that they are out of the way when pulling out the male connector platform that
these plugs are mating with.
• Never yank the lead wire to disconnect the plug from the male connector, or else damage to the
male connector may result.
• As shown above, there is a direction that the plug cannot be inserted onto the male connector.
● Components
DIP
6.5 mm height
from PCB surface
to the top of the plug
IDC
Wire
Soldering Crimping wrapping
Others