Product
Folder
Order
Now
Support &
Community
Tools &
Software
Technical
Documents
TPD2S300
SLVSDL1 – APRIL 2017
TPD2S300 USB Type C Short-to-VBUS and IEC ESD Protector for the CC Pins
•
•
•
•
2 Applications
•
•
•
•
•
•
Smartphones
Laptop PC
Tablets
Wall Adaptors
Power Banks
Power Drills
Finally, most systems require IEC61000-4-2 system
level ESD protection for their external pins. The
TPD2S300 integrates IEC 61000-4-2 ESD protection
for the CC1 and CC2 pins, removing the need to
place high voltage TVS diodes externally on the
connector.
Device Information(1)
PART
NUMBER
TPD2S300
WCSP (9)
1.40 mm × 1.40 mm
Application Diagram
Battery
Charger
Battery
5V
Since the release of the USB Type-C connector,
many products and accessories for USB Type-C have
been released which do not meet the USB Type-C
specification. One example of this is USB Type-C
Power Delivery adaptors that start out with 20 V on
the VBUS line. Another concern for USB Type-C is that
mechanical twisting and sliding of the connector could
short pins due to the close proximity they have in this
small connector. This can cause 20-V VBUS to be
shorted to the CC pins. Also, due to the close
proximity of the pins in the Type-C connector, there is
a heightened concern that debris and moisture is
going to cause the 20-V VBUS pin to be shorted to the
CC pins.
BODY SIZE (NOM)
(1) For all available packages, see the orderable addendum at
the end of the data sheet.
3 Description
The TPD2S300 is a single chip USB Type-C port
protection solution that provides 20-V Short-to-VBUS
overvoltage and IEC ESD protection for the CC1 and
CC2 pins.
PACKAGE
5 V ± 20 V
FET
OVP
FET
OVP, OCP
VBUS
•
2 Channels of Short-to-VBUS Overvoltage
Protection (CC1, CC2): 24-VDC Tolerant
2 Channels of IEC 61000-4-2 ESD Protection
(CC1, CC2)
Low quiescent current: 3.23 µA (Typical), VPWR,
VM = 3.3 V
CC1, CC2 Overvoltage Protection FETs 200 mA
capable for passing VCONN power
CC Dead Battery Resistors Integrated for handling
dead battery use case in mobile devices
1.4-mm × 1.4-mm WCSP Package
DC/DC
CC1
•
1
These non-ideal equipments and mechanical events
make it necessary for the CC pins to be 20-V
tolerant, even though they only operate at 5 V or
lower. The TPD2S300 enables the CC pins to be 20V tolerant without interfering with normal operation by
providing overvoltage protection on the CC pins. The
device places high voltage FETs in series on the CC
lines. When a voltage above the OVP threshold is
detected on these lines, the high voltage switches are
opened up, isolating the rest of the system from the
high voltage condition present on the connector.
CC Analog
USB PD Phy and Controller
Power Switch Control
TPD2S300
OVP and ESD
CC2
1 Features
Copyright © 2017, Texas Instruments Incorporated
1
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,
intellectual property matters and other important disclaimers. PRODUCTION DATA.
