O30E5.pdf 02.8.27
Please read rating and !CAUTION (for storage and operating, rating, soldering and mounting, handling) in this catalog to prevent smoking and/or burning, etc.
!Note •Please read rating and !CAUTION (for storage and operating, rating, soldering and mounting, handling) in this PDF catalog to prevent smoking and/or burning, etc.
•This catalog has only typical specifications. Therefore, you are requested to approve our product specification please approve our product specification or transact the approval sheet for product specification before ordering.
This catalog has only typical specifications because there is no space for detailed specifications. Therefore, or to transact the approval sheet for product specificaion before ordering.
Continued from the preceding page.
s Structure
Probe
OUT
IN
OUT
Without Probe
IN
With Probe
s Standard Land Dimensions
1. Standard pattern dimensions
Please design I/O pattern so that the impedance match 50
4
ohm including the land pattern.
2
1
The material of PCB is the epoxy resin of grass fabric base.
Through hole
0.5
(εr=4.8). Thickness is 1.0mm.
The solder resist should be printed except for the land
4.1
3.1
1
2.1
1
pattern on the PCB.
3
LAND
ELECTRODE
(1.5)
(1.5)
1.74
(in mm)
2. Standard metal mask pattern
There is possibility to have the contact failure by solder
0.5
shifting into contact point, if the excess solder is used by
3
1
2.3
non standard metal mask pattern.
3.5
1
2
3.5
The standard solder cream metal mask drawing
(Mask thickness 0.15mm)
4
(in mm)