ST
Sitronix
ST7773
262K Color Single-Chip TFT Controller/Driver
1. Introduction
ST7773 is a single-chip controller/driver for 262K-color, graphic type TFT-LCD. It consists of 528 source line and 220 gate
line driver circuits. This chip can be connected to a microprocessor direct through Serial Peripheral Interface (SPI) or
8-bits/9-bits/16-bits/18-bits parallel interface. The display data is stored in the on-chip Display Data RAM (DDRAM) of
176x220x18 bits. It can perform display data RAM read/write operation with no external operation clock to minimize power
consumption. In addition, because of the integrated power supply circuits necessary to drive liquid crystal, it is possible to
make a display system with fewer components.
2. Features
Single chip TFT-LCD Controller/Driver with RAM
Built-in Circuits
On-chip Display Data RAM (i.e. Frame Memory)
-
DC/DC converter
-
176 x 220 x 18 = 696,960 bits
-
Adjustable VCOM
LCD Driver Output Circuits:
-
4 preset gamma curves (1.0, 1.8, 2.2 & 2.5)
-
Source Outputs: 176 RGB channels
-
Oscillator for display clock generation
-
Gate Outputs: 220 channels
-
Timing controller
Display Resolution
Built-in NV Memory for LCD Initial Register Setting
-
-
7-bits for ID2
Display Colors (Color Mode)
-
7-bits for VCOM adjustment
-
Full Color: 262K, RGB=(666) max., Idle Mode OFF
Wide Supply Voltage Range
-
176 (RGB) x 220
Color Reduce: 8-color, RGB=(111), Idle Mode ON
-
I/O Voltage (VDDI to DGND): 1.6V~3.3V
Programmable Pixel Color Format (Color Depth) for
-
Analog Voltage (VDD to AGND): 2.7V~3.3V
Various Display Data input Format
On-Chip Power System
-
12-bit/pixel: RGB=(444) using whole frame memory
-
Source Voltage (GVDD to AGND): 3.0V~5.0V
-
16-bit/pixel: RGB=(565) using whole frame memory
-
VCOM HIGH level (VCOMH to AGND): 2.5V to 5.0V
-
18-bit/pixel: RGB=(666) using whole frame memory
-
VCOM LOW level (VCOML to AGND): -2.5V to 0.0V
-
Gate driver HIGH level (VGH to AGND):
Various Interfaces
-
Parallel 8080-series MCU Interface
-
3-line serial interface
+10.0V to 16V
-
(8-bit, 9-bit, 16-bit & 18-bit)
Gate driver LOW level (VGL to AGND):
-13V to -5.5V
Display Features
Operating Temperature: -30° to +85°
C
C
-
Programmable partial display duty
-
Line inversion, frame inversion
-
Supporting MVA type LC
-
Support both normal-black & normal-white LC
ST7773
8080 MCU Interface: 8-bit/9-bit/16-bit/18-bit
Serial Peripheral Interface : 3-line
Sitronix Technology Corp. reserves the right to change the contents in this document without prior notice
Ver. 2.0
1
2008-7-7