MX29LV002C/002NC T/B
MX29LV004C T/B
MX29LV008C T/B
CMOS SINGLE VOLTAGE 3V ONLY FLASH MEMORY
FEATURES
GENERAL FEATURES
• Byte mode only:
- 262,411 x8 (MX29LV002C/002NC)
- 524,288 x8 (MX29LV004C)
- 1,048,576 x8 (MX29LV008C)
• Sector Structure
- 16K-Byte x 1, 8K-Byte x 2, 32K-Byte x 1
64K-Byte x 3 (MX29LV002C), 64K-Byte x 7 (MX29LV004C), 64K-Byte x 15 (MX29LV008C)
• Sector Protect
- Provides sector protect function to prevent program or erase operation in the protected sector
- Provides chip unprotect function to allow code changing
- Provides temporary sector unprotect function for code changing in previously protected sector
• Single Power Supply Operation
- 2.7 to 3.6 volt for read, erase, and program operations
• Latch-up protected to 250mA from -1V to Vcc + 1V
• Low Vcc write inhibit : Vcc ≤ 1.4V
• Compatible with JEDEC standard
- Pinout and software compatible to single power supply Flash
PERFORMANCE
• High Performance
- Fast access time: 45Q (MX29LV004C only), 55Q (for MX29LV004C and MX29LV008C), 70/90ns
- Fast program time: 9us/Byte typical utilizing accelerate function
- Fast erase time: 0.7s/sector
• Low Power Consumption
- Low active read current: 7mA (typical) at 5MHz
- Low standby current: 200nA (typical)
• Minimum 100,000 erase/program cycle
• 20 years data retention
SOFTWARE FEATURES
• Erase Suspend/ Erase Resume
- Suspends sector erase operation to read data from or program data to another sector which is not being
erased
• Status Reply
- Data# Polling & Toggle bits provide detection of program and erase operation completion
• Support Common Flash Interface (CFI) only for 29LV002C/002NC, 29LV004C
HARDWARE FEATURES
• Ready/Busy# (RY/BY#) Output only for 29LV004C, 29LV008C
- Provides a hardware method of detecting program and erase operation completion
• Hardware Reset (RESET#) Input
- Provides a hardware method to reset the internal state machine to read mode
PACKAGE
• 32-Pin TSOP (for MX29LV002C/002NC)
• 32-Pin PLCC (for MX29LV002C/002NC and MX29LV004C)
• 40-Pin TSOP (for MX29LV004C and MX29LV008C), which is not recommended for new design in
• All devices are RoHS Compliant
P/N:PM1301
REV. 2.0, DEC. 15, 2011
1
