HOME在庫検索>在庫情報

部品型式

AT29LV040A-20TI

製品説明
仕様・特性

Features • • • • • • • • • • • • • • Single Voltage, Range 3V to 3.6V Supply 3-volt Only Read and Write Operation Software Protected Programming Fast Read Access Time – 150 ns Low Power Dissipation – 15 mA Active Current – 40 µA CMOS Standby Current Sector Program Operation – Single Cycle Reprogram (Erase and Program) – 2048 Sectors (256 Bytes/Sector) – Internal Address and Data Latches for 256 Bytes Two 16K Bytes Boot Blocks with Lockout Fast Sector Program Cycle Time – 20 ms Max Internal Program Control and Timer DATA Polling for End of Program Detection Typical Endurance > 10,000 Cycles CMOS and TTL Compatible Inputs and Outputs Commercial and Industrial Temperature Ranges Green (Pb/Halide-free) Packaging Option 4-megabit (512K x 8) 3-volt Only 256-byte Sector Flash Memory AT29LV040A 1. Description The AT29LV040A is a 3-volt only in-system Flash Programmable and Erasable Read Only Memory (PEROM). Its 4 megabits of memory is organized as 524,288 words by 8 bits. Manufactured with Atmel’s advanced nonvolatile CMOS EEPROM technology, the device offers access times to 150 ns, and a low 54 mW power dissipation. When the device is deselected, the CMOS standby current is less than 40 µA. The device endurance is such that any sector can typically be written to in excess of 10,000 times. The programming algorithm is compatible with other devices in Atmel’s 3-volt only Flash memories. To allow for simple in-system reprogrammability, the AT29LV040A does not require high input voltages for programming. Three-volt-only commands determine the operation of the device. Reading data out of the device is similar to reading from an EPROM. Reprogramming the AT29LV040A is performed on a sector basis; 256 bytes of data are loaded into the device and then simultaneously programmed. During a reprogram cycle, the address locations and 256 bytes of data are captured at microprocessor speed and internally latched, freeing the address and data bus for other operations. Following the initiation of a program cycle, the device will automatically erase the sector and then program the latched data using an internal control timer. The end of a program cycle can be detected by DATA polling of I/O7. Once the end of a program cycle has been detected, a new access for a read or program can begin. 0334G–FLASH–2/05

ブランド

ATM

供給状況

 
Not pic File
お探し製品AT29LV040A-20TIは、clevertechの営業担当が在庫調査を行いemailにて結果を御報告致します。

「見積依頼」ボタンを押してお気軽にお問合せください。

ご注文方法

弊社からの見積回答メールの返信又はFAXにてお願いします。


お取引内容はこちら

0.0613188744