1mm Pitch FPC/FFC Connector
FH 21 Series
sFeatures
1. LIF (Low Insertion Force) Mechanism
LIF mechanism secures mounting serviceability.
2. Kink Mechanism
DIP post is treated with kinks, and prevent connector
floating in the soldering process.
3. Contact Structure on Both Sides
The contact structure on both sides does restrict
directionality of FPC and FFC conductors.
sApplications
HDD, facsimiles, printers, and crystal liquie modules, etc.
sProduct Specifications
Rated Current: 0.5A
Rating
Operating Temperature Range: -30 ~ +70ç (Note 1) Storage Temperature Range: -10 ~ +50ç (Note 2)
Rated Voltage: 50V AC Operating Humidity Range: Relative humidity 90% max. Storage Humidity Range: Relative Humidity: 90% max.
(Not dewed)
Applicable FPC
(Not dewed)
t=0.3±0.05 Solder plating
Item
Specification
Condition
1. Insulation Resistance
500Mø min.
Measured at 100V DC
2. Withstand voltage
Neither short nor breakdown should occur
150V AC for 1 minute
3. Contact Resistance
4. Mechanical Operation
40mø
*FPC conductor resistance included
Contact resistance: 40mø max.
Measured at 100mA
10 cycles
No part should be damaged, cracked, or loosened
Electrical discontinuity, 1µS max.
5. Vibration
Frequency 10~55Hz and single amplitude 0.75mm in
Contact resistance: 40mø
3 directions for 2 hours, respectively.
No part should be damaged, cracked, or loosened
Electrical discontinuity, 1µS max.
6. Shock
Contact resistance: 40mø max.
No part should be damaged, cracked, or loosened
7. Moisture Resistance
7. in Steady State
Note 1.
Note 2.
Note 2.
Note 3.
Contact resistance: 40mø max.
Insulation resistance: 50Mø max.
Acceleration: 490m/s, duration: 11ms, sine half-wave
in 3 directions for 3 cycles, respectively
Exposed to temperature 60ç and humidity 90~95%
for 96 hours
No part should be damaged, cracked, or loosened
Temperature rise included when energized
This storage indicates a long-term storage state for the unused product before the board mounted.
The operating temperature and humidity ranges are applied to the non-energized state after the connector has been
installed in the board.
The above standards represent this series. The individual formal agreement should be based on the "Specification".
D15
