PA
FAMILY SERIES/PA•PAF•PAL CONNECTOR
Wire-to-board (Crimp style/IDC) / Wire-to-wire (Crimp style/IDC)
2.0mm
(.079") pitch
Features ––––––––––––––––––––––––
• Secure locking device
The housing has a locking device to prevent accidental
disconnection because of routing of wires or of vibration, and
also reverse and different circuit numbers mating.
• Interchangeable between crimp and IDC socket
Both crimp and IDC sockets use the same headers and wire-towire mating halves.
• Secondary retainers
Secondary retainers enhance safety in case of partial insertion
or accidental release of the contact.
• Harness variation
PAL, wire-to-wire crimp style connector, increases wire harness variation.
PA connector
(Standard type, Retainer mountable type)
• Highly reliable contact
Based upon wire-to-board crimp style PA
connectors, the PA series family of
connector have been expanded to meet the
requirement of complex wire harness of
2.0mm (.079") pitch connectors with secure
locking mechanism thanks to the
additional line up of wire-to-board IDC style
PAF connectors and wire-to-wire crimp
style PAL connectors.
The box contact supplies stable contact performance even under
conditions of vibration, distortion, low voltage or low current.
• Insertion guide mechanism
Header has housing insertion guides for easy and secure insertion.
• Flanged press pin
Top entry type header has flanged press pins, preventing
accidental removal of the pins that might result from the
distorted unmating especially in the case of small No. of circuits.
PAF connector
• The industry’s first secure lock IDC connectors
Retainer
PA Receptacle
(Crimp style Standard type)
Retainer
PAF Receptacle
(IDC style)
Retainer
PA Receptacle
(Crimp style Retainer mountable type)
• Metallic strain relief
PA Shorouded header
(Top entry type)
PA Shorouded header
(Side entry type)
PAF Receptacle
(IDC style)
PA Shorouded header
(Top entry type)
PAL
(Crimp style Wire-to-wire)
Retainer
* Contact JST if Lead-Free product is required.
* Refer to "General Instruction and Notice when using
Terminals and Connectors" at the end of this catalog.
* Contact JST for details.
Standards ––––––––––––––––––––––
0
1
By separating ID section and secure lock section, the industry’s first
secure lock specification has been achieved for IDC that was said
to be impossible. Our fully automatic IDC machines, BCD-M5BP
(for simple harness) and CAM-M12B, SAD-M12E (for multiharness), can be applied for harness making.
Recognized E60389
Metallic strain relief on the contact securely grips wire insulation that
can avoid direct stress of vibration or impact. The same grip strength
as insulation barrel of crimp style contact could be achieved.
• Retainer with four locking points
The new four locking points design ensures wire retention force
of every direction that is almost superior to contact retention
force of crimp style connectors. It also completely covers
exposed terminated ID contact.
PAL connector
• The industry’s first wire to wire 2.0mm (.079")
pitch retainer mountable type connector.
• Either with or without panel lock can be
selected according to application.
Certified LR20812
61
