MT9T001 - 1/2-Inch 3-Megapixel Digital Image Sensor
Features
1/2-Inch 3-Megapixel CMOS Digital
Image Sensor
MT9T001P12STC
For the latest data sheet, refer to Aptina’s Web site: www.aptina.com
Features
Table 1:
•
•
•
•
•
•
•
•
Optical format
Active imager size
High frame rate
Global reset release
Horizontal and vertical binning
Column and row skip modes
Superior low-light performance
Low dark current
Simple two-wire serial interface
Programmable controls: Gain, frame rate, frame size,
exposure
• Pin-for-pin compatible with Aptina’s 1.3-megapixel
MT9M001 and 2-megapixel MT9D001
Parameter
Active pixels
Pixel size
Color filter array
Shutter type
Maximum data rate/
master clock
QXGA
(2,048 x 1,536)
UXGA
Frame (1,600 x 1,200)
rate
SXGA
(1,280 x 1,024)
XGA
(1,024 x 768)
VGA (640 x 480)
ADC resolution
Responsivity
Dynamic range
SNRMAX
Supply voltage
Power consumption
Applications
• Digital still cameras
• Digital video cameras
• Converged DSCs/camcorders
General Description
The Aptina® MT9T001 is a QXGA-format 1/2-inch
CMOS active-pixel digital image sensor with an active
imaging pixel array of 2,048H x 1,536V. It incorporates
sophisticated camera functions on-chip such as windowing, column and row skip mode, and snapshot
mode. It is programmable through a simple two-wire
serial interface.
The 3-megapixel CMOS image sensor features Aptina’s
breakthrough low-noise CMOS imaging technology
that achieves CCD image quality (based on signal-tonoise ratio and low-light sensitivity) while maintaining
the inherent size, cost, and integration advantages of
CMOS.
Operating temperature
Packaging
Typical Value
1/2-inch (4:3)
6.55mm(H) x 4.92mm(V)
8.19 (Diagonal)
2,048H x 1,536V
3.2μm x 3.2μm
RGB Bayer pattern
Global reset release (GRR),
electronic rolling shutter (ERS)
48 MPS/48 MHz
Programmable up to 12 fps
Programmable up to 20 fps
Programmable up to 27 fps
Programmable up to 43 fps
Programmable up to 93 fps
10-bit, on-chip
>1.0 V/lux-sec (550nm)
61dB
43dB
3.0V−3.6V (3.3V nominal)
240mW (nominal);
2?W (standby)
0°C to +60°C
48-pin PLCC
The MT9T001 produces extraordinarily clear, sharp
digital pictures, and its ability to capture both continuous video and single frames makes it the perfect choice
for a wide range of consumer and industrial applications, including digital still cameras, digital video cameras, and PC cameras.
The sensor can be operated in its default mode or programmed by the user for frame size, exposure, gain setting, and other parameters. The default mode outputs
a QXGA image at 12 frames per second (fps). An onchip analog-to-digital converter (ADC) provides 10 bits
per pixel. FRAME_VALID and LINE_VALID signals are
output on dedicated pins, along with a pixel clock that
is synchronous with valid data.
PDF:2227034164/Source:9267007275
MT9T001_DS - Rev. G 5/11 EN
Key Performance Parameters
1
.
.
©2004 Aptina Imaging Corporation All rights reserved.
