HOME在庫検索>在庫情報

部品型式

C410C103M5R5CA7200

製品説明
仕様・特性

Multilayer ceramic capacitors are available in a variety of physical sizes and configurations, including leaded devices and surface mounted chips. Leaded styles include molded and conformally coated parts with axial and radial leads. However, the basic capacitor element is similar for all styles. It is called a chip and consists of formulated dielectric materials which have been cast into thin layers, interspersed with metal electrodes alternately exposed on opposite edges of the laminated structure. The entire structure is fired at high temperature to produce a monolithic block which provides high capacitance values in a small physical volume. After firing, conductive terminations are applied to opposite ends of the chip to make contact with the exposed electrodes. Termination materials and methods vary depending on the intended use. TEMPERATURE CHARACTERISTICS Class III: General purpose capacitors, suitable Ceramic dielectric materials can be formulated with a wide range of characteristics. The EIA standard for for by-pass coupling or other applications in which ceramic dielectric capacitors (RS-198) divides ceramic dielectric losses, high insulation resistance and dielectrics into the following classes: stability of capacitance characteristics are of little or no importance. Class III capacitors are similar to Class II capacitors except for temperature characteristics, Class I: Temperature compensating capacitors, which are greater than ± 15%. Class III capacitors suitable for resonant circuit application or other applihave the highest volumetric efficiency and poorest cations where high Q and stability of capacitance charstability of any type. acteristics are required. Class I capacitors have predictable temperature coefficients and are not effected by voltage, frequency or time. They are made KEMET leaded ceramic capacitors are offered in from materials which are not ferro-electric, yielding the three most popular temperature characteristics: superior stability but low volumetric efficiency. Class I C0G: Class I, with a temperature coefficient of 0 ± capacitors are the most stable type available, but have 30 ppm per degree C over an operating the lowest volumetric efficiency. temperature range of - 55°C to + 125°C (Also known as “NP0”). X7R: Class II, with a maximum capacitance Class II: Stable capacitors, suitable for bypass change of ± 15% over an operating temperature or coupling applications or frequency discriminating range of - 55°C to + 125°C. circuits where Q and stability of capacitance charZ5U: Class III, with a maximum capacitance acteristics are not of major importance. Class II change of + 22% - 56% over an operating temcapacitors have temperature characteristics of ± 15% perature range of + 10°C to + 85°C. or less. They are made from materials which are ferro-electric, yielding higher volumetric efficiency but less stability. Class II capacitors are affected by Specified electrical limits for these three temperature temperature, voltage, frequency and time. characteristics are shown in Table 1. SPECIFIED ELECTRICAL LIMITS TEMPERATURE CHARACTERISTICS C0G X7R Z5U PARAMETER Dissipation Factor: Measured at following conditions: C0G — 1 kHz and 1 vrms if capacitance > 1000 pF 1 MHz and 1 vrms if capacitance ≤ 1000 pF X7R — 1 kHz and 1 vrms* or if extended cap range 0.5 vrms Z5U — 1 kHz and 0.5 vrms Dielectric Strength: 2.5 times rated DC voltage. 0.15% 2.5% 4.0% Pass Subsequent IR Test Insulation Resistance (IR): At rated DC voltage, whichever of the two is smaller 1,000 MΩ-µF or 100 GΩ 1,000 MΩ-µF or 100 GΩ 1,000 MΩ-µF or 10 GΩ Temperature Characteristics: Range, °C Capacitance Change without DC voltage -55 to +125 0 ± 30 ppm/°C -55 to +125 ±15% +10 to +85 +22%, -56% * 1 MHz and 1 vrms if capacitance ≤ 100 pF on military product. Table I © KEMET Electronics Corporation, P.O. Box 5928, Greenville, S.C. 29606, (864) 963-6300 3 Multlayer Ceramic Capacitors MULTILAYER CERAMIC CAPACITORS/AXIAL & RADIAL LEADED

ブランド

KEMET

会社名

KEMET Corporation

本社国名

U.S.A

事業概要

EMI Cores,EMI Filters,Ferrite Products,Flex Suppressors,Inductors, Piezo Actuators,Relays,Transformers/Magnetics Aluminum Electrolytic,Ceramic,Film,KO-CAP (Polymer),Supercapacitors (EDLCs),Tantalum

供給状況

 
Not pic File
お求め製品C410C103M5R5CA7200は、当社営業スタッフが在庫調査を行いemailにて結果を御連絡致します。

「見積依頼」ボタンを押してお気軽にお進み下さい。

送料

お買い上げ小計が1万円以上の場合は送料はサービスさせて頂きます。
1万円未満の場合、また時間指定便はお客様負担となります。
(送料は地域により異なります。)


お取引内容はこちら

0.0659089088