LTC1064-2
Low Noise, High Frequency,
8th Order Butterworth Lowpass Filter
U
FEATURES
■
■
■
■
■
■
■
DESCRIPTIO
8th Order Filter in a 14-Pin Package
140kHz Maximum Corner Frequency
No External Components
50:1 and 100:1 Clock to Cutoff Frequency Ratio
80µVRMS Total Wideband Noise
0.03% THD or Better
Operates from ±2.37V to ±8V Power Supplies
U
APPLICATIO S
■
■
■
Antialiasing Filters
Smoothing Filters
Tracking High Frequency Lowpass Filters
The LTC®1064-2 is a monolithic 8th order lowpass
Butterworth filter, which provides a maximally flat passband. The attenuation slope is –48dB/octave and the
maximum attenuation is in excess of 80db. An external
TTL or CMOS clock programs the filter’s cutoff frequency.
The clock to cutoff frequency ratio is 100:1 (Pin 10 at
V –) or 50:1 (Pin 10 at V +). The maximum cutoff frequency
is 140kHz. No external components are needed.
The LTC1064-2 features low wideband noise and low
harmonic distortion even for input voltages up to 3VRMS.
In fact the LTC1064-2 overall performance competes with
equivalent multiple op amp RC active realizations. The
LTC1064-2 is available in a 14-pin DIP or 16-pin surface
mounted SW package. The LTC1064-2 is fabricated using
LTC’s enhanced analog CMOS Si-gate process.
The LTC1064-2 is pin compatible with the LTC1064-1.
, LTC and LT are registered trademarks of Linear Technology Corporation.
U
TYPICAL APPLICATIO
8th Order Clock Sweepable
Lowpass Butterworth Filter
1
Measured Frequency Response
0
14
OUT C
LTC1064-2
2
13
NC
VIN
8V
4
5
6
7
AGND
V+
AGND
NC
RIN A
V–
fCLK
50/100
VOUT
NC
12
11
–15
–30
–8V
CLOCK = 5MHz
10
VOUT/VIN (dB)
3
VS = ±7.5V
NC
–45
–60
9
–75
8
–90
–105
1064 TA01a
NOTE: THE POWER SUPPLIES SHOULD BE BYPASSED BY A 0.1µF
CAPACITOR CLOSE TO THE PACKAGE. THE NC PINS 1, 6, 8,
AND 13 SHOULD BE PREFERABLY GROUNDED.
0
100
200 300 400 500
FREQUENCY (kHz)
600
700
1064-2 TA01b
10642fa
1
