LARGE CAPACITANCE ALUMINUM ELECTROLYTIC CAPACITORS
Inverter-use screw terminal 85C
RWF
@350 to 550Vdc
@Load life with ripple current : 85C 2000 hours
longer life
RWE
?SPECIFICATIONS
Items
Characteristics
Operating
Temperature Range
-25 to +85C
350 to 550Vdc
P20% (M)
I=0.02CV or 5mA, whichever is smaller.
Where, I : Max. leakage current (MA), C : Nominal capacitance (MF), V : Rated voltage (V)
Rated Voltage Range
Capacitance Tolerance
Leakage Current
Dissipation Factor
(tane)
(at 20C, 120Hz)
(at 20C after 5 minutes)
0.25 max.
(at 20C, 120Hz)
350 to 450V 500 & 550V
Rated Voltage (Vdc)
0.7min.
0.6min.
C(-25C)/C(+20C)
(at 120Hz)
When measured between the terminals shorted each other and the mounting clamp on the insulating sleeve covering the case by using
an insulation resistance meter of 500Vdc, the insulation resistance shall not be less than 100MO.
When a voltage of 2000Vac is applied for 1 minute between the terminals shorted each other and the mounting clamp on the insulating
sleeve covering the case, there shall not be electrical damage.
The following specifications shall be satisfied when the capacitors are restored to 20C after subjected to DC voltage with the maximum
ripple current is applied for 2000 hours at 85C.
Capacitance change
[P20% of the initial value
DF (tanE)
[300% of the initial specified value
Leakage current
[The initial specified value
The following specifications shall be satisfied when the capacitors are restored to 20C after exposing them for 500 hours at 85C
without voltage applied.
Capacitance change
[P20% of the initial value
DF (tanE)
[300% of the initial specified value
Leakage current
[The initial specified value
Capacitance change
Low Temperature
Characteristics
Insulation Resistance
Insulation
Withstanding Voltage
Load Life
Shelf Life
?DIMENSIONS (Terminal type=LG) [mm]
@B type of mounting clamp
AP1
WP1
8
J
GP1
L+4max.
fD
35
50
63.5
76
F35 to F63.5 : G=6
F76 & F89 : G=5
A
58
78
90
104.5
B
44
64
76
90
W
48
68
80
93.5
H
3.5
4.5
4.5
4.5
F
12.7
22.4
28.0
31.5
fD
50
63.5
76
89
4.5
KP1
EP1
6
30°P5°
360°
3
45°P5°
H
BP1
FP1
FD+1.8max.
Sleeve
@C type of mounting clamp
E
32.5
38.1
44.5
50.8
K
37.0
43.5
50.0
56.5
* The screw and the mounting clamp are separately supplied and not attached to the product.
?PART NUMBERING SYSTEM
RWE 550
LG
820
M
C
C13
Case code
Type of mounting clamp, if required
Cap tolerance (P20%)
Nominal cap in MF
Screw terminal type
Rated voltage in volts
Series name
F
22.4
28.0
31.5
31.5
J
14.0
14.0
14.0
16.0
Plus hexagon-headed screw:
M5B0.8B10
Maximum screw tightening torque:
3.23Nm