– PRODUCT OBSOLETE / UNDER OBSOLESCENCE –
0
XC9536 In-System
Programmable CPLD
R
DS064 (v7.0) May 17, 2013
0
5
Product Specification
Features
Description
•
•
5 ns pin-to-pin logic delays on all pins
fCNT to 100 MHz
•
•
•
36 macrocells with 800 usable gates
Up to 34 user I/O pins
5V in-system programmable
- Endurance of 10,000 program/erase cycles
- Program/erase over full commercial voltage and
temperature range
Enhanced pin-locking architecture
Flexible 36V18 Function Block
- 90 product terms drive any or all of 18 macrocells
within Function Block
- Global and product term clocks, output enables,
set and reset signals
Extensive IEEE Std 1149.1 boundary-scan (JTAG)
support
Programmable power reduction mode in each
macrocell
Slew rate control on individual outputs
User programmable ground pin capability
Extended pattern security features for design
protection
High-drive 24 mA outputs
3.3V or 5V I/O capability
Advanced CMOS 5V FastFLASH™ technology
Supports parallel programming of more than one
XC9500 concurrently
Available in 44-pin PLCC, 44-pin VQFP, 48-pin CSP
packages
The XC9536 is a high-performance CPLD providing
advanced in-system programming and test capabilities for
general purpose logic integration. It is comprised of eight
36V18 Function Blocks, providing 800 usable gates with
propagation delays of 5 ns. See Figure 2 for the architecture
overview.
•
•
•
•
•
•
•
•
•
•
Power dissipation can be reduced in the XC9536 by configuring macrocells to standard or low-power modes of operation. Unused macrocells are turned off to minimize power
dissipation.
Operating current for each design can be approximated for
specific operating conditions using the following equation:
ICC (mA) = MCHP (1.7) + MCLP (0.9) + MC (0.006 mA/MHz) f
Where:
MCHP = Macrocells in high-performance mode
MCLP = Macrocells in low-power mode
MC = Total number of macrocells used
f = Clock frequency (MHz)
Figure 1 shows a typical calculation for the XC9536 device.
(83)
e
manc
erfor
High P
Typical ICC (mA)
•
•
Power Management
(50)
(50)
er
w Pow
Lo
(30)
0
50
100
Clock Frequency (MHz)
DS064_01_110101
Figure 1: Typical ICC vs. Frequency for XC9536
© 1998, 2003-2006, 2013 Xilinx, Inc. All rights reserved. All Xilinx trademarks, registered trademarks, patents, and disclaimers are as listed at http://www.xilinx.com/legal.htm.
All other trademarks and registered trademarks are the property of their respective owners. All specifications are subject to change without notice.
DS064 (v7.0) May 17, 2013
Product Specification
www.xilinx.com
1