AZ725
MINIATURE
POWER RELAY
FEATURES
•
•
•
•
•
•
•
Dielectric strength 5000 Vrms
20 Amp switching — single pole contacts
Isolation spacing greater than 8mm
Molded materials: all 94 V–0
VDE 6010 - unsealed version only
Sealed version available
UL, CUR file E43203
CONTACTS
GENERAL DATA
Arrangement
SPST (1 Form A)
SPDT (1 Form C)
Ratings
Resistive load:
Max. switched power: 480 W or 5000 VA
Max. switched current: 20 A
Max. switched voltage: 150* VDC or 400 VAC
*Note: If switching voltage is greater than 30 VDC, special
precautions must be taken. Please contact the factory.
Rated Load
Minimum operations
2 x 107
1 x 105 at 16 A 240 VAC Res.
Operate Time (typical)
7 ms at nominal coil voltage
Release Time (typical)
3 ms at nominal coil voltage
(with no coil suppression)
Dielectric Strength
5000 Vrms coil to contact
(at sea level for 1 min.) 1000 Vrms between open contacts
Resistance
< 30 milliohms initially
COIL
Power
Dropout
Greater than 10% of nominal coil voltage
At nominal coil voltage
-40°C (-40°F) to 85°C (185°F)
-40°C (-40°F) to 130°C (266°F)
0.062" DA at 10–55 Hz
Shock
Silver cadmium oxide
1000 megohms min. at 20°C, 500 VDC,
50% RH
Vibration
Material
Insulation
Resistance
Ambient Temperature
Operating
Storage
UL
20 A at 250 VAC resistive
Life Expectancy
Mechanical
Electrical
10 g
Enclosure
P.B.T. polyester
At Pickup Voltage
(typical)
270 mW
Terminals
Tinned copper alloy
Max. Continuous
Dissipation
2.6 W at 20°C (68°F) ambient
2.0 W at 40°C (104°F) ambient
Max. Solder Temp.
270°C (518°F)
Temperature Rise
32°C (58°F) nominal coil voltage
Max. Solder Time
5 seconds
Max. 130°C (266°F)
Max. Immersion Time
30 seconds
Max. Solvent Temp
80°C (176°F)
Weight
19 grams
Temperature
NOTES
1. All values at 20°C (68°F).
2. Relay may pull in with less than “Must Operate” value.
3. Specifications subject to change without notice.
1/15/13
