DA CONNECTOR
2.0mm pitch/Board-in Insulation displacement connectors
T
JS
Specifications –––––––––––––––––––
• Current rating: 1.0A AC, DC (AWG #26)
• Voltage rating: 100V AC, DC
• Temperature range: -25˚C to +85˚C
(including temperature rise in applying
electrical current)
• Insulation resistance:
1,000M Ω min.
• Withstanding voltage: 800V AC/minute
• Applicable wire: UL1571, 1061(Contact JST for details regarding
other UL styles.)
AWG #28, #26
Conductor/7 strands, tin-coated
Insulation O.D./ 0.9 to 1.0mm
• Applicable PC board thickness: 1.2, 1.6mm
* Compliant with RoHS.
* Refer to "General Instruction and Notice when using
Terminals and Connectors" at the end of this catalog.
* Contact JST for details.
Measuring 2.0mm in pitch, 5.0mm in
mounting height, and 4.0mm in thickness,
this board-in connector is useful in
miniaturizing the connections of small
electronic products, such as VCRs,
cameras, stereo systems, and car radios.
This connector can be used by itself or in
combination with the DR connector.
• Compact and low profile
• Twin U-slot insulation displacement section
• Easy mounting onto printed circuit boards
• Strain relief
• Interchangeability
Standards ––––––––––––––––––––––
0
Recognized E60389
1Certified LR20812
PC board layout (viewed from soldering side) and Assembly layout
5.0
2.0min
1.9min
4.0
2.0 ±0.05
φ0.8 ±0.05
Note: 1. Tolerances are non-cumulative: ±0.05mm for all centers.
2. Hole dimensions differ according to the kind of PC board and piercing
method. The dimensions above should serve as a guideline.
Contact JST for details.
1
3. Pulling or otherwise putting a strain on the harness attached to the connector
before the solder has completely cooled can dislodge the connector or cause
its misalignment.
4. Do not reuse any connectors that were previously soldered and then
removed from a PC board.