HOME＞在庫検索＞在庫情報
MCR01MZSF2402
MCR01 Resistors Thick film rectangular MCR01 (1005 size : 1 / 16W) !Features 1) Extremely small light Area ratio is 60% smaller than that of chip 1608, while weight ratio has been cut 75%. 2) Highly reliable chip resistor Ruthenium oxide dielectric offers superior resistance to the elements. 3) Electrodes not corroded by soldering Thick film makes the electrodes very strong. 4) Flat surface further facilitates mounting Mounting can also be automated. 5) ROHM resistors have approved ISO–9001 certification. Design and specifications are subject to change without notice. Carefully check the specification sheet supplied with the product before using or ordering it. !Ratings Item Rated power Conditions Specifications Power must be derated according to the power derating curve in Figure 1 when ambient temperature exceeds 70°C. 0.063W (1 / 16W) at 70°C 100 POWER LOAD (%) 80 60 40 20 0 −55 0 70 100 125 AMBIENT TEMPERATURE (°C) Fig.1 Rated voltage The voltage rating is calculated by the following equation. If the value obtained exceeds the limiting element voltage, the voltage rating is equal to the maximum operating voltage. E= P×R Nominal resistance Operating temperature E: Rated voltage (V) P: Rated power (W) R: Nominal resistance (Ω) Limiting element voltage 50V See Table 1. −55°C to +125°C 1/5 MCR01 Resistors !External dimensions (Units : mm) 1 0.2±0.1 2 3 No. +0.05 0.25 −0.1 Material 2 External electrode coated with Sn/Pb or Sn Alumina substrate Overcoating (J, F : glass, D : resin) 0.5±0.05 Nickel-coated secondary electrode 6 4 Thick film of palladium-silver for primary electrode 3 5 5 Thick dielectric glaze of ruthenium (only silver used for jumper) 4 1.0±0.05 0.35±0.05 1 6 !Packaging Reel Taping P0 P2 φD0 E F A0 W 02 04 06 08 06 D 04 B 02 A 08 B0 P1 Heat crimp cover/Tape Thick paper (Underside paper tape) Chip resistor Square punchout hole mount T2 C (Units : mm) Label W F E A0 B0 8.0±0.3 3.5±0.05 1.75±0.1 0.7±0.1 1.2±0.1 EIAJ ET-7200A compliant (Units : mm) A φ180 B 0 −3 φ60 C +1 0 9 +1.0 0 D D0 φ1.5 +0.1 0 P0 P1 P2 T2 4.0±0.1 2.0±0.05 2.0±0.05 Max. 1.1 φ13±0.2 Bulk case Slider Shutter EIAJ ET-7201A compliant 12±0.1 0 36 −0.2 110±0.7 (Units : mm) 3/5
ROHM
ローム株式会社
日本
炭素皮膜抵抗の特許を元に創業した。社名のROHM（R:抵抗 Ohm:抵抗を示す単位）はそこに由来する。その後、大規模集積回路の製造を手がけ始め、現在は様々な機能を顧客の要望に応じてLSI上に集積するカスタムLSIが主力となっている。
お買い上げ小計が１万円以上の場合は送料はサービスさせて頂きます。１万円未満の場合、また時間指定便はお客様負担となります。（送料は地域により異なります。）
