Toggles
Series JS01 & JS03
Rockers
General Specifications
Electrical Capacity (Resistive Load)
Programmable Illuminated PB
Pushbuttons
Other Ratings
Keylocks
Contact Resistance:
Insulation Resistance:
Dielectric Strength:
Mechanical Life:
Electrical Life:
Total Travel:
Materials & Finishes
Actuator:
Cover:
Base:
Contacts:
Terminals:
Rotaries
Slides
Switching Rating:
Nonswitching Rating:
H
Environmental Data
Operating Temp Range:
Humidity:
Vibration:
Shock:
25mA @ 24V DC
0.1A @ 50V DC
50 milliohms maximum
100 megohms minimum @ 500V DC
500V AC minimum for 1 minute minimum
2,000 operations minimum
2,000 operations minimum
For slide actuator: .031” (0.8mm); for piano actuator: .114” (2.9mm)
JS01 Slide DIP
Glass fiber reinforced polyamide
Glass fiber reinforced polyamide (UL94V-0)
Glass fiber reinforced polyamide (UL94V-0)
Beryllium copper with gold plating
Brass with gold plating
JS03 Piano DIP
Glass fiber reinforced PBT
Glass fiber reinforced PBT (UL94V-0)
Glass fiber reinforced PBT (UL94V-0)
Phosphor bronze with gold plating
Phosphor bronze with gold plating
–25°C through +70°C (–13°F through +158°F)
90 ~ 95% humidity for 96 hours @ 40°C (104°F)
10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning
in 1 minute; 3 right angled directions for 2 hours
50G (490m/s2) acceleration (tested in 6 right angled directions, with 5 shocks in each direction)
Tilt
Tactiles
Ultra-Miniature Slide & Piano DIP
Indicators
Touch
PCB Processing
Soldering:
Cleaning:
Standards & Certifications
Flammability Standards:
UL 94V-0 rated cover & base
The JS series devices have not been tested for UL recognition and CSA certification.
These switches are designed for use in a low-voltage, low-current circuit.
When used as intended in a low-voltage, low-current circuit, the results do not produce
hazardous energy.
Supplement
Accessories
Wave Soldering Recommended. See Profile A in Supplement section.
Manual Soldering: See Profile A in Supplement section.
Note: Switches are packaged in OFF position and should be soldered in OFF position.
These devices are not process sealed. Hand clean locally using alcohol based solution.
H18
www.nkk.com
