Photomicrosensor (Transmissive)
EE-SX460-P1
■ Dimensions
■ Features
Note: All units are in millimeters unless otherwise indicated.
•
•
•
•
•
•
171826-3
(Tyco Electronics AMP)
Optical
axis
■ Absolute Maximum Ratings (Ta = 25°C)
0.5 (Aperture
width)
Item
Optical
axis
Two,
R1
Snap-in mounting model.
Mounts to 0.8- to 1.6-mm-thick panels.
High resolution (aperture width of 0.5 mm)
With a 5-mm-wide slot.
Photo IC output signals directly connect with C-MOS and TTL.
Connects to Tyco Electronics AMP’s EI-series connectors.
Symbol
Rated value
Power supply voltage
VOUT
28 V
Output current
IOUT
16 mA
Permissible output dissipation
POUT
250 mW (see note)
Ambient
temperature
Mounting face
10 V
Output voltage
15±0.2
VCC
Operating
Topr
–20°C to 75°C
Storage
Tstg
–40°C to 85°C
Tsol
---
Soldering temperature
Internal Circuit
V
Unless otherwise specified, the
tolerances are as shown below.
Note: Refer to the temperature rating chart if the ambient temperature
exceeds 25°C.
O
G
Dimensions
Tolerance
3 mm max.
±0.3
Name
3 < mm ≤ 6
±0.375
V
Power supply
(Vcc)
6 < mm ≤ 10
±0.45
O
G
Output (OUT)
Ground (GND)
10 < mm ≤ 18
±0.55
18 < mm ≤ 30
±0.65
Terminal No.
■ Ordering Information
Description
Model
Photomicrosensor (transmissive)
EE-SX460-P1
Recommended Mating Connectors:
Tyco Electronics AMP 171822-3 (crimp connector)
172142-3 (crimp connector)
OMRON
EE-1005 (with harness)
■ Electrical and Optical Characteristics (Ta = 25°C, VCC = 5 V±10%)
Item
Symbol
Value
Condition
ICC
30 mA max.
Low-level output voltage
VOL
0.3 V max.
IOUT = 16 mA with incident
High-level output voltage
VOH
(VCC x 0.9) V min.
VOUT = VCC without incident, RL = 47 kΩ
Response frequency
f
3 kHz min.
VOUT = VCC, RL = 47 kΩ (see note)
Current consumption
With and without incident
Note: The value of the response frequency is measured by
rotating the disk as shown below.
Disk
2.1 mm
0.5 mm
0.5 mm
t = 0.2 mm
Photomicrosensor (Transmissive)
EE-SX460-P1
209