Product Obsolete/Under Obsolescence
0
XC95144 In-System
Programmable CPLD
R
DS067 (v6.0) May 17, 2013
0
5
Product Specification
Features
Description
•
•
7.5 ns pin-to-pin logic delays on all pins
fCNT to 111 MHz
•
•
•
144 macrocells with 3,200 usable gates
Up to 133 user I/O pins
5V in-system programmable
- Endurance of 10,000 program/erase cycles
- Program/erase over full commercial voltage and
temperature range
Enhanced pin-locking architecture
Flexible 36V18 Function Block (FB)
- 90 product terms drive any or all of 18 macrocells
within Function Block
- Global and product term clocks, output enables,
set and reset signals
Extensive IEEE Std 1149.1 boundary-scan (JTAG)
support
Programmable power reduction mode in each
macrocell
Slew rate control on individual outputs
User programmable ground pin capability
Extended pattern security features for design
protection
High-drive 24 mA outputs
3.3V or 5V I/O capability
Advanced CMOS 5V FastFLASH technology
Supports parallel programming of more than one
XC9500 concurrently
Available in 100-pin PQFP, 100-pin TQFP, and 160-pin
PQFP packages
The XC95144 is a high-performance CPLD providing
advanced in-system programming and test capabilities for
general purpose logic integration. It is comprised of eight
36V18 Function Blocks, providing 3,200 usable gates with
propagation delays of 7.5 ns. See Figure 2 for the architecture overview.
•
•
•
•
•
•
•
•
•
•
•
Power dissipation can be reduced in the XC95144 by configuring macrocells to standard or low-power modes of
operation. Unused macrocells are turned off to minimize
power dissipation.
Operating current for each design can be approximated for
specific operating conditions using the following equation:
ICC (mA) = MCHP (1.7) + MCLP (0.9) + MC (0.006 mA/MHz) f
Where:
MCHP = Macrocells in high-performance mode
MCLP = Macrocells in low-power mode
MC = Total number of macrocells used
f = Clock frequency (MHz)
Figure 1 shows a typical calculation for the XC95144
device.
600
nce
orma
erf
igh P
(480)
H
Typical ICC (mA)
•
Power Management
400
(320)
wer
w Po
(300)
Lo
200
(160)
0
50
100
Clock Frequency (MHz)
DS067_01_110101
Figure 1: Typical ICC vs. Frequency for XC95144
© 1998–2009, 2013 Xilinx, Inc. XILINX, the Xilinx logo, Virtex, Spartan, ISE, and other designated brands included herein are trademarks of Xilinx in the United States and other
countries. All other trademarks are the property of their respective owners.
DS067 (v6.0) May 17, 2013
Product Specification
www.xilinx.com
1