Data Sheet
Low Power, Precision Analog Microcontroller,
Dual Sigma-Delta ADCs, Flash/EE, ARM7TDMI
ADuC7060/ADuC7061
FEATURES
Analog input/output
Dual (24-bit) ADCs
Single-ended and differential inputs
Programmable ADC output rate (4 Hz to 8 kHz)
Programmable digital filters
Built-in system calibration
Low power operation mode
Primary (24-bit) ADC channel
2 differential pairs or 4 single-ended channels
PGA (1 to 512) input stage
Selectable input range: ±2.34 mV to ±1.2 V
30 nV rms noise
Auxiliary (24-bit) ADC: 4 differential pairs or 7 singleended channels
On-chip precision reference (±10 ppm/°C)
Programmable sensor excitation current sources
200 μA to 2 mA current source range
Single 14-bit voltage output DAC
Microcontroller
ARM7TDMI core, 16-/32-bit RISC architecture
JTAG port supports code download and debug
Multiple clocking options
Memory
32 kB (16 kB × 16) Flash/EE memory, including 2 kB kernel
4 kB (1 kB × 32) SRAM
Tools
In-circuit download, JTAG based debug
Low cost, QuickStart™ development system
Communications interfaces
SPI interface (5 Mbps)
4-byte receive and transmit FIFOs
UART serial I/O and I2C (master/slave)
On-chip peripherals
4× general-purpose (capture) timers including
Wake-up timer
Watchdog timer
Vectored interrupt controller for FIQ and IRQ
8 priority levels for each interrupt type
Interrupt on edge or level external pin inputs
16-bit, 6-channel PWM
General-purpose inputs/outputs
Up to 14 GPIO pins that are fully 3.3 V compliant
Power
AVDD/DVDD specified for 2.5 V (±5%)
Active mode: 2.74 mA (@ 640 kHz, ADC0 active)
10 mA (@ 10.24 MHz, both ADCs active)
Rev. F
Packages and temperature range
Fully specified for −40°C to +125°C operation
32-lead LFCSP (5 mm × 5 mm)
48-lead LFCSP and LQFP
Derivatives
32-lead LFCSP (ADuC7061)
48-lead LQFP and 48-lead LFCSP (ADuC7060)
APPLICATIONS
Industrial automation and process control
Intelligent, precision sensing systems, 4 mA to 20 mA
loop-based smart sensors
GENERAL DESCRIPTION
The ADuC7060/ADuC7061 series are fully integrated, 8 kSPS,
24-bit data acquisition systems incorporating high performance
multichannel sigma-delta (Σ-Δ) analog-to-digital converters
(ADCs), 16-bit/ 32-bit ARM7TDMI® MCU, and Flash/EE memory
on a single chip.
The ADCs consist of a primary ADC with two differential pairs or
four single-ended channels and an auxiliary ADC with up to seven
channels. The ADCs operate in single-ended or differential input
mode. A single-channel buffered voltage output DAC is available
on chip. The DAC output range is programmable to one of four
voltage ranges.
The devices operate from an on-chip oscillator and a PLL generating an internal high frequency clock up to 10.24 MHz. The
microcontroller core is an ARM7TDMI, 16-bit/32-bit RISC
machine offering up to 10 MIPS peak performance; 4 kB of SRAM
and 32 kB of nonvolatile Flash/EE memory are provided on chip.
The ARM7TDMI core views all memory and registers as a single
linear array.
The ADuC7060/ADuC7061 contains four timers. Timer1 is a
wake-up timer with the ability to bring the part out of power saving
mode. Timer2 is configurable as a watchdog timer. A 16-bit PWM
with six output channels is also provided. The ADuC7060/
ADuC7061 contains an advanced interrupt controller. The
vectored interrupt controller (VIC) allows every interrupt to be
assigned a priority level. It also supports nested interrupts to a
maximum level of eight per IRQ and FIQ. When IRQ and FIQ
interrupt sources are combined, a total of 16 nested interrupt levels
is supported. On-chip factory firmware supports in-circuit serial
download via the UART serial interface ports and nonintrusive
emulation via the JTAG interface. The parts operate from 2.375 V
to 2.625 V over an industrial temperature range of −40°C to
+125°C.
Document Feedback
Information furnished by Analog Devices is believed to be accurate and reliable. However, no
responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other
rights of third parties that may result from its use. Specifications subject to change without notice. No
license is granted by implication or otherwise under any patent or patent rights of Analog Devices.
Trademarks and registered trademarks are the property of their respective owners.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781.329.4700 ©2009–2017 Analog Devices, Inc. All rights reserved.
Technical Support
www.analog.com
