LPC660
www.ti.com
SNOS554D – MAY 1998 – REVISED MARCH 2013
LPC660 Low Power CMOS Quad Operational Amplifier
Check for Samples: LPC660
FEATURES
DESCRIPTION
•
•
•
•
•
•
•
•
•
•
•
•
The LPC660 CMOS Quad operational amplifier is
ideal for operation from a single supply. It features a
wide range of operating voltages from +5V to +15V
and features rail-to-rail output swing in addition to an
input common-mode range that includes ground.
Performance limitations that have plagued CMOS
amplifiers in the past are not a problem with this
design. Input VOS, drift, and broadband noise as well
as voltage gain (into 100 kΩ and 5 kΩ) are all equal
to or better than widely accepted bipolar equivalents,
while the power supply requirement is typically less
than 1 mW.
1
2
Rail-to-rail output swing
Micropower operation: (1 mW)
Specified for 100 kΩ and 5 kΩ loads
High voltage gain: 120 dB
Low input offset voltage: 3 mV
Low offset voltage drift: 1.3 μV/°C
Ultra low input bias current: 2 fA
Input common-mode includes V−
Operation range from +5V to +15V
Low distortion: 0.01% at 1 kHz
Slew rate: 0.11 V/μs
Full military temp. range available
APPLICATIONS
•
•
•
•
•
•
•
High-impedance buffer
Precision current-to-voltage converter
Long-term integrator
High-impedance preamplifier
Active filter
Sample-and-Hold circuit
Peak detector
This chip is built with National's advanced DoublePoly Silicon-Gate CMOS process.
See the LPC662 datasheet for a Dual CMOS
operational amplifier and LPC661 datasheet for a
single CMOS operational amplifier with these same
features.
Application Circuit
Oscillator frequency is determined by R1, R2, C1, and C2:
fOSC = 1/2πRC
where R = R1 = R2 and C = C1 = C2.
Figure 1. Sine-Wave Oscillator
1
2
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
All trademarks are the property of their respective owners.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of the Texas
Instruments standard warranty. Production processing does not
necessarily include testing of all parameters.
Copyright © 1998–2013, Texas Instruments Incorporated
